 |
|
 |
 |
 |
|
 |
|
Equipment:
The ice making equipment shall be a completely factory assembled unit of the harvesting type provided by TURBO REFRIGERATING COMPANY. The equipment shall have the following features:
Evaporater sections
The evaporater section shall utilize vertical evaporater plates made of 304 stainless steel.
Water distribution
The equipment shall have a stainless water distribution pan and be provided with all water distribution piping.
Frames
The frames (HP) shall be fully welded and hot dip galvanized after fabrication.
The frames(IGC) shall be fully welded and coated with a rust preventative primer and water proof finish.
The frames(IGC) shall be fully welded and coated with a rust preventative primer and water proof finish.
Cabinets
The cabinets shall be insulated with 2" of foam urethane and suitable for outdoor application. The outer panels shall be protected with an approved exterior finish.
Compressor
The compressor shall be of the open(semi-hermetic) reciprocating type complete with motor and starter, or screw compressor with motor or starter.
Condensers
The condenser shall be of the evaporative type,(water cooled),(air cooled).
Refrigerant piping
The refrigerant piping shall utilize direct expansion valves, hot gas harvesting valves and a suction line accumulator with integral liquid suction interchanger, receiver designed to hold entire refrigerant charge. All vessels shall be constructed in accordance with the ASME Pressure Vessel Code.
Controls
Controls shall be electric or electronic and include all ice harvesting controls, water level controls, and refrigeration controls.
TESTING:
All system components are operationally checked before shipping.
Full factory run tests are available upon request.
Full factory run tests are available upon request.
  |